Genie garage door opener keypad manual code#

Compatible with all Intellicode equipped Genie garage door openers Auto-Seek Dual Frequency (315/390 MHz) provides strong, secure signals that minimize interference and improve performance. 3 Enter New PIN+PROG, the red LED light on the keypad will blink slowly 2-5 times and go out. Genie’s Wireless Garage Door Opener Keypad is an exterior access system for your garage without the need for a remote or a physical key.

On the keypad enter your PIN and press the # button. 1 Hold down PROG+6+Up/Dwn, the red LED light on the keypad will go out. On the key pad press the 3, 5 and 7 buttons in. Slide the keypad cover all the way open until it latches. Resetting the keypad: slide the keypad cover to half way open. Slide the keypad cover all the way closed.

Genie garage door opener keypad manual code#

Enter the 3 or 4 digit code from the DIP switch location and press the * button. The red indicator light should flash twice per second. Enter your desired PIN followed by the # button. The red indicator light should flash once per second. On the key pad press the 3, 5 and 7 buttons in order. (remotes, wall console, and keypad) with the powerhead. Note that each specific Genie remote model section in blue, shown below, is not compatible with the other blue remote model section. While holding the # and 8 buttons slide the keypad cover open until it latches, then release the # and 8 buttons. Now that your Genie garage door opener is installed, you will want to program the opener so that. Genie Garage Door Opener Models and Genie Remote Listings GENIE COMMON PLATFORM RESIDENTIAL OPERATORS There are 2-types of Radio Controls shown in this list, all use a base 390 mhz frequency. Press the # and 8 buttons at the same time. Resetting the keypad: slide the keypad cover to half way open. (You will use groups of 3 to determine the code) DIP Switch Position Codes Up-Up-Up =7 Up-Up-Down=6 Up-Down-Up=5 Up-Down-Down=4 Down-Up-Up=3 Down-Up-Down=2 Down-Down-Up=1 Down-Down-Down=0 First determine you’re PIN to use to open your garage door it can be a 4-8 digit number of your choosing. You will have a 3 digit code for 9 DIP switches and a 4 digit code for 12 DIP switches. Programming Instructions for the GWKP Genie garage door opener keyless entry involves following the two sets of steps below: To erase the old PIN (personal identification number) press and hold down, in order, the PROG, 6 and Up/Down Arrow keys. (The locations will be either up or down) The following list will help finding the code. To program this keypad you will need to note the location of the DIP switches on the opener motor. The Genie Model GWK Wireless Keypad is for use with the older Genie openers with 9 or 12 DIP switches.